1Is this my Problem?
Here are the most common scenarios we hear from our customers experiencing the Bosch 8.0 & 9.0 ABS Module Repair failure and what you will notice.

Observable Symptoms:
- Scanner shows specific pump motor circuit faults
- Internal valve coil malfunction codes
- Intermittent ABS and Traction Control warning lights
A framework for being sure
- Read codes with a scanner that talks to the ABS controller. A generic reader only sees engine codes and will tell you nothing here.
- Wiggle the wheel speed sensor harness at each hub while watching live data. A fault that does not react to the harness is inside the module.
- Clear the codes and restart. A valve relay or pump motor circuit fault that returns instantly is an internal MOSFET or driver failure, not a sensor.
Now you know for sure you have this problem.
2Solutions
Mail-In Repair
Pull the module out yourself and let the professionals repair it.
Text to StartFull Service
Relax, our local trusted technicians will get you back on the road today.
Dispatch3Pull the Part
Tools you may need:
- T30 Torx Bit
- 10mm Wrench
- 1/4" Ratchet
Parts you may need:
- None required for removal
- Disconnect the negative battery terminal with a 10mm wrench and wait five minutes for the system to bleed down.
- Release the locking bail on the ABS harness connector and unplug it.
- Remove the four T30 Torx screws holding the electronic controller to the hydraulic valve block.
- Lift the controller straight off the valve block, keeping the solenoid pins straight.
- Leave every brake line sealed; the controller separates from the hydraulic unit, so no bleeding is required.
4Fix It
Tools you may need:
- Hot Air Rework Station
- Temperature-Controlled Soldering Iron
- Desoldering Braid
- Magnifying Lamp
Parts you may need:
- 63/37 Leaded Solder
- Replacement Power MOSFET Matched to the Board
- No-Clean Flux Paste
- Open the potted controller housing and pick the sealing compound away from the power section of the board.
- Inspect the solenoid and pump motor pins for cracked joints and the power MOSFETs for burnt or lifted legs.
- Desolder the failed MOSFET with the hot air station at 350C and lift it off with tweezers.
- Install the matched replacement MOSFET, then reflow every solenoid pin with 63/37 leaded solder at 700F.
- Clean with isopropyl alcohol, re-seal the housing, reinstall, and clear the codes with a bidirectional scanner.
Skip the headache. We'll fix it today.
Choose your city below to book our mobile technician directly to your driveway.
Nationwide Mail-In Repair
Not in Missouri or Colorado? Remove the module and mail it to us. 24-hour turnaround with a lifetime warranty.
Text to Start Mail-In

